See important guidance on the use of this record.

If you have any comments or new information about this record, please email us.

Summary

Mine shaft forming part of the 19th century Eylesbarrow Tin Mine

Location

Protected Status

• Scheduled Monument 1021055: Eylesbarrow Tin Mine and associated remains

Other References/Statuses

• National Monuments Record: 1300505
• Old DCC SMR Ref: SX56NE/27/55
• Old SAM Ref: 34467(P)

Monument Type(s) and Dates

• MINE SHAFT (XVIII to XIX - 1750 AD to 1900 AD (Between))

Full description

Untitled Source (Migrated Record). SDV248125.

Des=mpp/157278.

Ordnance Survey, 1880-1899, First Edition Ordnance 25 inch map (Cartographic). SDV336179.

Feature not shown on 19th century map.

Gerrard, S., 1990-2002, Monument Protection Programme. Archaeological Item Dataset., MPP 157278 (Report - Survey). SDV277946.

Site visited on 9th May 2002. Shaft 580 metres south-south-west of Eylesbarrow, forming part of Eylesbarrow Tin Mine. The shaft is about 3 metres deep and has a central and very steep sided rectangular shaped collapsed area. Remainder is less steep and is covered in heather, grass and rushes. Dumps around all sides stand up to 1.5 metres high. Heather and grass. On the south eastern side material upcast from the shaft lies upon the earlier field boundary.

Newman , P., 1999, Eylesbarrow (Ailsborough) Tin Mine, 6-10, Figure 2 (Report - Survey). SDV352201.

Shaft not shown on English Heritage survey.

English Heritage, 2005, Industrial Survey Information (Report - Survey). SDV346396.

GeoInformation Group Ltd, 2010, 1:625 2010 Colour (12.5cm resolution) (Aerial Photograph). SDV346026.

Shaft shown on aerial photograph.

English Heritage, 2013, Pastscape, 1300505 (Website). SDV352645.

Remains of nineteenth century mine shafts and adits at Eylesbarrow Tin Mine, which was mined from 1814 until 1856. An English Heritage archaeological field survey identified 25 shaftheads of which 16 have names recorded in documentary sources.
Most of the shaftheads comprise conical pits between 9 metres and 16 metres in diameter, surrounded on the downslope side by either a crescentic or linear spoil dump up to 3 metres high. Some also have remains of masonry collars. It is likely that the majority of the shafts would originally have had collars, particularly those associated with winding or pumping equipment but they were destroyed or obscured when the shafts were capped after abandonment. At least five of the shafts were associated with pumping equipment, powered by the two waterwheels located on the lower flanks of the hill. Three shafts have evidence of balance bob pits built into the upper rim of the shafthead. Six of the shafts were used for winding.

Sources / Further Reading

Associated Monuments

Associated Finds: none recorded

Associated Events

• EDV4966 - Survey of Drizzlecombe, Eylesbarrow, Ditsworthy and Hartor
• EDV6239 - Eylesbarrow (Ailsborough) Tin Mine

Search results generated by the HBSMR Gateway from exeGesIS SDM Ltd.